LCP-BL-K - Lightning Cable Protection Kit

LCP-BL-K
LCP-BL-K

Product Details

Manufacturer:
Shrinkflex
Manufacturer Part #:
LCP-BL-K

Unit Price: $4.99

Total Price: $4.99

Product Details

ManufacturerShrinkflex
Manufacturer Part #LCP-BL-K

Product Description


Cord Repair Heatshrink Kits

Lightning Cable Protection & Repair Kit

Are you tired of having to replace your lost or damaged Apple cords and chargers? Wirecare is here to help you. We have a variety of different techniques and products that could help you protect those valued cords!

Do your charging cords always rip where the cord enters the connector end? I’m sure you’ve seen a variety of expensive products that can prevent that from happening. However, Wirecare has a simple, easy and inexpensive method that is just as effective. We offer Heatshrink Tubing in a variety of colors and sizes that can add extra support and stability to those brittle cable ends. Heatshrink Tubing can be installed by following a few easy steps. This kit is compatible with the Lightning Cable Only

The Lightning cord is used with the following Apple products: iPhone 5S and Later, Ipod Tocuh 5th Gen and Later, Ipad Mini, Ipad 4th Gen and Later, and Ipad Pro.

Kit Contents:
  • 1 ft - 3/8" 3:1 Polyolefin Heatshrink Tubing (In selected color)
  • 1 ft - 1/2" 3:1 Polyolefin Heatshrink Tubing (In selected color)
  • 6 in. - Hot Fusion Adhesive Tape
  • Instruction Booklet

Step by Step Installation

Step 1:

Determine the correct size of Heatshrink based on your cable end. Choose the heatshrink size that fits snug but still allows the cable end to travel through.

Step 2:

Measure the length of Heat Shrink you need, making sure that it covers the damaged section (if applicable). Although you do not need to cover any part of the cable end, it is recommended to help keep the Heat Shrink from slipping.

Step 3:

Mark where to cut the Heat Shrink, and cut along designated line.

Step 4:

Using the Heat Shrink for reference, cut a strip of adhesive that will slide into the Heat Shrink along side the cable. Adhesive is Optional but recommended

Step 5:

It is ok if the adhesive seperates from it’s backing, the tape will not be sticky to the touch. It will become sticky once heated.

Step 6:

If our cable is damaged, remove any excess rubber or coating prior to applying Heat Shrink.

Step 7:

Slide the cut piece of Heat Shrink over the cable end. Depending on the size of the cable, it may be a very tight fit. If it does not fit your Heat Shrink may require some stretching. To do so, insert two dowels into the Heat Shrink and force them apart gently, continue to do so until the Heat Shrink fits over the cable end. Warning: If Heatshrink rips while stretching it will not work properly.

Step 8:

Check if your cable end has lights or anything else you shouldn’t cover while positioning the Heat Shrink. If applying adhesive, remove the backing and insert the strip along side the cable.

Step 9:

Once the Heat Shrink and Adhesive Strip are positioned properly, use a Heat Gun or other source of heat to heat the Heat Shrink slowly and evenly. This may take a few minutes, please be patient. Hold farther down the cable to prevent burning yourself.

Step 10:

Your cable is now protected or repaired!


Technical Specifications

ColorBlue

Total Price: $4.99


 Top of Page